User Guide

Garmin G1000 EIS Pilot’s Guide for Mooney M20M & M20R 190-00447-01 Rev. A 7-6
ENGINE INDICATION SYSTEM
7.3 SYSTEM
The System Page is accessible by pressing the SYSTEM
softkey. Beneath the Tachometer is a color-coded horizon
-
tal bar indicator for fuel quantity (normally aspirated) or
fuel pressure (turbocharged), followed by numeric read-
outs for oil pressure, oil temperature and engine hours
(tach). The fuel calculations reside below the engine in-
dicators. A numeric readout is provided for fuel flow, and
gallons remaining.
The fuel calculation portion of the System Page is based
on the fuel flow totalizer and displays the following:
• FFLOW GPH – Fuel flow in gallons per hour.
• GAL REM – Quantity of fuel remaining in gallons.
Below the fuel calculations is a color-coded horizontal
bar indicator with a numeric readout for EGT (normally
aspirated). Located at the bottom of the page are the elec
-
trical indicators. A numeric readout is provided for bus
voltage and battery amperage.
If desired, the pilot can utilize the DEC FUEL, INC
FUEL and RST FUEL softkeys to adjust the amount of
fuel remaining for totalizer calculations.
• DEC FUEL – Decreases totalizer based fuel quan-
tity remaining in one gallon increments.
• INC FUEL – Increases totalizer based fuel quan-
tity remaining in one gallon increments.
• RST FUEL – Reset totalizer based fuel quantity
remaining relative to the aircraft fuel capacity.
To decrease the fuel totalizer quantity:
1. From the System Page, press the
DEC FUEL
softkey to obtain the desired number of gallons
remaining.
To increase the fuel totalizer quantity:
1. From the System Page, press the
INC FUEL
softkey to obtain the desired number of gallons
remaining.
To reset the fuel totalizer:
1. From the System Page, press the
RST FUEL
softkey. This also resets the GAL REM to the
aircraft fuel capacity.
NOTE: Fuel calculations do not use the aircraft
fuel quantity indicators and are calculated from
the last time the fuel was reset.
NOTE: If any parameters are exceeded the system
automatically switches back to the default
Engine Page.