User Guide

190-00592-00 Rev. AGarmin G1000 Pilot’s Guide for the Diamond DA403-12
NAV/COM
Selecting the DME Transceiver Tuning Mode
The following DME transceiver tuning modes can be
selected:
• NAV1 – Tunes the DME frequency from the selected
NAV1 frequency.
• NAV2 – Tunes the DME frequency from the selected
NAV2 frequency.
• HOLD – When transitioning from NAV1 or NAV2
mode to HOLD mode, the DME frequency remains
set to the last selected NAV frequency.
To select a DME transceiver tuning mode:
1. Turn the
large FMS knob to place the selection
cursor over the DME tuning mode field.
2. Turn the
small FMS knob to select the desired
DME tuning mode.
3. Press the
ENT key to validate the selection.
NOTE: Pressing the CLR key while in the process
of selecting DME tuning mode causes the system
to cancel data entry and revert back to the previ-
ously selected DME tuning mode.
NOTE: Please refer to the Primary Flight Display
section for information on the DME Information
window.
Figure 3-23 Selecting DME Tuning Mode