User Guide

ManualsBrandsGarmin ManualsOtherG1000 DIAMOND PILOTS GUIDE

190-00592-00 Rev. AGarmin G1000 Pilot’s Guide for the Diamond DA403-10

NAV/COM

Tuning and Transferring ADF Frequencies

ADF frequencies in the 190.0 kHz to 1799.5 kHz fre-

quency range can be entered in the standby ADF frequen-

cy ﬁeld of the ADF/DME Tuning window, using both the

dual FMS knob and the ENT key.

To enter an ADF frequency in the standby

ﬁeld:

1. Turn the

large FMS

knob to place the selection

cursor over the standby ADF frequency ﬁeld.

2. Turn the

small FMS

knob both to initiate data

entry and to change each digit, and turn the

large FMS

knob to move the cursor to the next

or previous character position.

3. Press the

ENT

key to validate data entry for the

standby frequency.

Figure 3-19 Entering ADF Standby Frequencies

Press the ENT

key to validate

the standby ADF

frequency entered.

Turn the

small FMS

knob both to activate

data entry mode for

the standby ADF

frequency ﬁeld and

to change each digit.

Turn the large

FMS knob to move

the cursor to the

next or previous

character position.

NOTE: The active ADF frequency ﬁeld cannot be

edited directly.

NOTE: Pressing the CLR key while in data entry

mode (i.e., before having validated a standby

frequency being entered) causes the system to

cancel the current data entry for this ﬁeld and

revert back to the previously entered standby

ADF frequency.

NOTE: The G1000 system does not support tuning

of the 2182.0 kHz ADF emergency frequency.

To transfer the active and standby ADF fre-

quencies:

1. Turn the

large FMS

knob to place the selection

cursor over the standby ADF frequency ﬁeld.

2. Press the

ENT

key.

Figure 3-20 Transferring ADF Frequencies

NOTE: Pressing the CLR key when the selection

cursor is ﬂashing over the standby ADF frequency

field clears the existing standby frequency,

replaces it with ‘0000.0’ and puts the cursor in

data entry mode for this ﬁeld.