User Guide

Garmin G1000 Pilot’s Guide for the Diamond DA40190-00592-00 Rev. A
7-69
MULTI FUNCTION DISPLAY
An arrival can be loaded from the Arrival Information
Page.
To load an arrival procedure from the
Arrival Information Page:
1. Select the desired arrival, transition and runway
using the steps described previously.
2. Press
MENU to display the Arrival Information
Page Options.
3. Turn the
large FMS knob to highlight ‘LOAD
ARRIVAL’ and press the ENT key.
4. The Active Flight Plan Page is displayed. Press
FPL to return to the Airport Arrival information
Page.
Loading an arrival procedure into the active flight plan
does NOT automatically alter the active flight plan leg or
Direct-to navigation. Once loaded, the arrival is simply
placed at the end of the flight plan. To manually transition
to a loaded arrival, see the procedure below (an alternative
method would be to remove the first occurrence of the
destination airport identifier).
To manually transition to a loaded arrival
procedure:
1. From the Active Flight Plan Page, press the
FMS
knob to activate the cursor and scroll down
through the list of loaded arrival waypoints.
2. When the desired loaded arrival waypoint
is highlighted, press the
D irect-to key, then
press ENT to highlight the ‘Activate’ prompt
(note that any loaded arrival waypoint may be
selected).
3. Press
ENT again to confirm activate
APPROACH INFORMATION PAGE
The Approach Information page shows the available
approach procedures for a selected airport. Where
multiple initial approach fixes (IAFs) and feeder routes are
available, that information may also be displayed. A map
image provides a layout diagram for each approach and
transition. To display the Airport Approach Information
Page press the APR softkey.
To scroll through the available approaches
and transitions:
1. Press the
FMS knob to activate the cursor.
2. Turn the
large FMS knob to place the cursor on
the ‘APPROACH’ procedure name field.
3. Turn the
small FMS knob to display a window
of available approaches for the selected airport.
Continue turning the small or
large FMS knob
to select the desired approach.
4. Press the
ENT key. The cursor moves to the
transitions (TRANS) field.
5. Turn the
small FMS knob to display a window
of available transitions. Continue turning the
small or
large FMS knob to select the desired
transition or select ‘VECTORS’ for guidance
only along the final course segment of the
approach. Press the
ENT key. NOTE: the cursor
moves through the remaining fields but they
are not selectable.
6. To remove the flashing cursor, press the
FMS
knob.