User Guide

5-41
GPS NAVIGATION
190-00649-00 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA42
Available
Approaches
Approach
Display
Figure 5-28 Selecting an Approach
Selecting an approach procedure using the PROC Key:
1) From the Navigation Map Page, press the PROC Key. The Procedures Window is displayed.
2) Highlight ‘SELECT APPROACH’.
3) Press the ENT Key. The APPROACH window is displayed on the ‘PROC – APPROACH LOADING’ Page.
4) Select an approach (Figure 5-28).
5) Press the ENT Key. The TRANSITION window is displayed.
6) Select a transition (the ‘VECTORS’ option assumes vectors will be received to the final course segment of the
approach and will provide navigation guidance relative to the final approach course.)
7) Press the ENT Key.
8) ‘LOAD?’ is highlighted. ‘LOAD’ adds the approach to the flight plan without immediately using the approach
for navigation guidance. This allows for the original flight plan to continue navigating until cleared for the
approach, but keeps the approach available for quick activation when needed. ‘ACTIVATE’ adds the approach
to the flight plan and begins navigating the approach course.
9) Press the ENT Key. If the approach is not approved for GPS, a ‘NOT APPROVED FOR GPS’ messages is displayed
with ‘YES’ highlighted. Press the ENT Key to acknowledge the message and load the approach. To cancel the
approach, select ‘NO’ and press the
ENT Key.