User Guide

190-00649-00 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA42
4-27
AUDIO PANEL AND CNS
Transferring the active and standby ADF frequencies:
1) Turn the large FMS Knob to place the selection cursor over the standby ADF frequency field.
2) Press the ENT Key.
Press the ENT key
to Transfer ADF
Frequencies
Figure 4-31 Transferring ADF Frequencies
The following ADF Modes can be selected:
• ANT (antenna) – The ADF bearing pointer parks at 90 degrees on the HSI. NDB audio can be heard by
selecting the ADF Key on the audio panel.
• ADF – The ADF pointer points to the relative bearing of the NDB station. NDB audio can be heard by
selecting the ADF Key on the audio panel.
• BFO (Beat Frequency Oscillator) – Provides an audible tone when a frequency is received. This allows
identification of the interrupted carrier beacon stations used in various parts of the world. It also confirms
receipt of the NDB signal.
Selecting the ADF Receiver Mode:
1) Turn the large FMS Knob to place the selection cursor over the ADF Mode Field.
2) Turn the small FMS Knob to select the desired ADF Receiver Mode.
Figure 4-32 Selecting ADF Receiver Mode