User Guide

190-00592-01 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA40/40F
2-15
FLIGHT INSTRUMENTS
Changing the selected GPS CDI setting:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the ‘Selected’ field in the ‘GPS CDI’ Box.
4) Turn the small FMS Knob to highlight the desired setting and press the ENT Key.
Figure 2-21 System Setup Page,
GPS CDI Settings
BEARING POINTERS AND INFORMATION WINDOWS
NOTE: Refer to the Audio Panel and CNS Section for information on tuning the radios.
NOTE: ADF radio installation is optional.
Two bearing pointers and associated information can be displayed on the HSI by pressing the PFD Softkey
then a BRG Softkey. Use the BRG Softkey to cycle through bearing sources (NAV, GPS, ADF). The pointers
are light blue and are single- (BRG1) or double-lined (BRG2); an icon is shown in the respective information
window to indicate the pointer type. The bearing pointers never override the CDI and are visually separated
from the CDI by a white ring (shown when bearing pointers are selected but not necessarily visible due to
data unavailability).
Frequency
Tuning Mode
Distance
DME Label
Figure 2-22 HSI with Bearing and DME Information
Bearing 2
Pointer
Bearing 1
Information
Window
Bearing 1
Pointer
Bearing 2
Information
Window
DME
Information
Window
No
Waypoint
Selected
Pointer
Icon
Bearing
Source
Pointer
Icon
Distance to
Bearing Source
Station
Identifier
Bearing
Source