User Guide

190-00592-02 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA40/40F
5-85
GPS NAVIGATION
TRIP PLANNING
Figure 5-80 Trip Planning Page
Trip Planning
Page Softkeys
Trip Statistics
Other Statistics
Fuel Statistics
Page Mode
Inset Map
Input Data
The Trip Planning Page (Figure 5-80) displays calculated statistics regarding the projected path of flight, based
on a number of input parameters provided. There are two modes of entering the projected flight path, a flight
plan mode and a waypoint entry mode. There are two sources of input data, manually entered by the user, or
automatically updated through input sensors and equipment. The Trip Planning Page displays the following:
• An Inset Map showing the selected flight plan or flight leg. This map has an appropriate scale in order to see
the selection. If there is no selected flight path the map shows the current position.
• The selected flight plan number and selected leg number (in flight plan mode). The selected leg number may
be the entire flight plan.
• The selected ‘FROM’ and ‘TO’ waypoints. In waypoint mode these are the selected waypoints. In flight plan
mode with a specific leg selected the waypoints shown are the endpoints of the selected leg. In flight plan
mode with the entire flight plan selected the waypoints shown are the start and end waypoints of the selected
flight plan. In automatic flight plan mode with active flight plan selected, the ‘from’ waypoint is the present
position and the ‘to’ waypoint is the end of the selected leg.
• DEP TIME (departure time) - The depature time displayed on the Trip Panning Page defaults to the current
time while in ‘AUTOMATIC’ mode, since the present position (P.POS) is considered to be the departure
point.
• GS - ground speed
• FUEL FLOW
• FUEL ONBOARD