User Guide

Garmin G1000 Pilot’s Guide for the Diamond DA40/40F
190-00592-02 Rev. A5-36
GPS NAVIGATION
DUPLICATE WAYPOINTS
As an identifier, facility name or location is entered, the G1000’s Spell’N’Find™ feature scrolls through
the database, displaying those waypoints matching the characters which have been entered to that point. If
duplicate entries exist for the entered facility name or location, additional entries may be viewed by continuing
to turn the small
FMS Knob during the selection process. If duplicate entries exist for an entered identifier, a
duplicate waypoint appears once you select the identifier (Figure 5-31).
Figure 5-31 Duplicate Waypoints
Loading a frequency in the standby COM or NAV frequency field:
1) With the Airport Information Page displayed, press the FMS Knob to activate the cursor.
2) Move the cursor to the Frequencies Box.
3) Turn the FMS Knob to scroll through the list, placing the cursor on the desired frequency. If a listed frequency
has additional information for the pilot to view, the frequency is preceded by an info (‘i’) designation. Press the
E NT Key to view the information. The following may be displayed with the frequency:
• ‘TX’ – transmit only
• ‘RX’ – receive only
• ‘PT’ – part time frequency
• ‘i’ – additional information exists, press the ENT Key
4) Press the E NT Key to place the selected frequency in the standby field of the COM or NAV window.
5) Press the FMS Knob to remove the cursor.
Loading a pilot control lighting frequency into selected COM standby frequency:
1) With the Airport Information Page displayed, press the FMS Knob to activate the cursor.
2) Move the cursor to the ‘PCL FREQ’ field in the Runways Window.
3) Press the E NT Key to place the PCL frequency in the standby field of the COM window.
4) Press the FMS Knob to remove the cursor.