User Guide

190-00552-00 Rev. A
Garmin G1000 Pilot’s Guide for the Columbia 350/400
2-15
FLIGHT INSTRUMENTS
Changing the selected GPS CDI setting:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the ‘SELECTED’ field in the ‘GPS CDI’ box.
4) Turn the small FMS Knob to highlight the desired setting and press the ENT Key.
Figure 2-21 System Setup Page,
GPS CDI Settings
BEARING POINTERS AND INFORMATION WINDOWS
NOTE: When the Arc HSI is displayed, the bearing information windows and pointers are disabled.
NOTE: Refer to the Audio Panel and CNS Section for information on tuning the radios.
Two bearing pointers and associated information (Figure 2-22) can be displayed on the HSI by selecting
the PFD Softkey then a BRG Softkey. Use the BRG Softkey to cycle through bearing sources (NAV, GPS).
The pointers are light blue and are single- (BRG1) or double-lined (BRG2); an icon is shown in the respective
information window to indicate the pointer type. The bearing pointers never override the CDI and are
visually separated from the CDI by a white ring (shown even when bearing pointers are selected but not
necessarily visible due to data unavailability).
Figure 2-22 HSI with Bearing Information
Bearing 2
Pointer
Bearing 1
Information
Window
Bearing 1
Pointer
Bearing 2
Information
Window
Pointer
Icon
Distance to
Bearing Source
Station
Identifier
Bearing
Source
No
Waypoint
Selected
Pointer
Icon
Bearing
Source