User Guide

190-00494-00 Rev. B
Garmin G1000 Pilot’s Guide for the Cessna Citation Mustang
2-27
FLIGHT INSTRUMENTS
DESTINATION ELEVATION
The destination elevation can be set in the Timer/References Window. This is the only user input the
pressurization controller requires. Refer to the EICAS Section for more information on cabin pressurization.
Setting the destination elevation:
1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to highlight the ‘DEST ELV’ field.
3) Use the small FMS Knob to enter the destination elevation (in 10-ft increments from -1,000 to 14,000 feet).
4) To remove the window, press the CLR Key or the TMR/REF Softkey.
SYSTEM TIME
The system time is displayed in the lower right corner of the PFD. Three display formats are available, local
12-hr, local 24-hr, and Coordinated Universal Time (UTC). Time and date are obtained from the GPS satellites
and cannot be changed, although a time offset may be entered (±HH:MM) for local times.
Figure 2-39 System Time
Configuring the system time:
1) Select the AUX - System Setup Page using the FMS Knob.
2) Press the FMS Knob to activate the cursor. ‘Time Format’ is highlighted.
3) Turn the small FMS Knob to select the desired format.
4) Press the ENT Key to confirm selection. ‘Time Offset’ is highlighted.
5) Enter the desired time offset (±HH:MM).
6) Press the ENT Key to confirm selection.
Figure 2-40 System Setup Page,
Date/Time Settings