User Guide

190-00494-00 Rev. B
Garmin G1000 Pilot’s Guide for the Cessna Citation Mustang
2-5
FLIGHT INSTRUMENTS
VSPEED REFERENCES
NOTE: Refer to the AFM for Vspeed values.
NOTE: V
REF
cannot be set above the indicated value for V
APR
.
Vspeeds can be changed and their flags turned on/off from the Timer/References Window. When active
(on), the Vspeeds are displayed at their respective locations to the right of the airspeed scale. By default, all
Vspeed values are reset and all flags turned off when power is cycled.
Vspeed Flag
Takeoff
V
1
1
V
R
R
V
2
2
V
ENR
E
Landing
V
APR
AP
V
REF
RF
Table 2-1 Vspeed Flag Labels
Vspeeds are categorized as either takeoff or landing. Takeoff Vspeed flags are automatically turned off when
airspeed reaches 160 knots. The order in which the categories are displayed is determined by whether the
aircraft is on the ground or in the air. If the aircraft is on the ground, the takeoff Vspeeds are displayed at the
top of the Vspeed list (Figure 2-5). If the aircraft is in the air, the landing Vspeeds are displayed at the top.
Changing Vspeeds and turning flags on/off:
1) Press the TMR/REF Softkey.
2) Turn the large FMS Knob to highlight the desired Vspeed.
3) Use the small FMS Knob to change the Vspeed in 1-kt increments (when a speed has been changed from a
default value, an asterisk appears next to the speed).
4) Press the ENT Key or turn the large FMS Knob to highlight the ON/OFF field
5) Turn the small FMS Knob clockwise to ON or counterclockwise to OFF.
6) To remove the window, press the CLR Key or the TMR/REF Softkey.
Vspeed flags can be turned on or off all at once or by category (takeoff and landing). Default values for
all or a category of Vspeeds can also be restored using a menu option (by pressing the
MENU Key while the
Timer/References Window is displayed).