User Guide

190-00494-00 Rev. B
Garmin G1000 Pilot’s Guide for the Cessna Citation Mustang
1-37
SYSTEM OVERVIEW
• Weight (pounds, kilograms)
Affects aircraft weights on the Weight Planning Page.
• Position (HDDD°MM.MM’, HDDD°MM’SS.S”)
Affects all position displays.
Changing the NAV ANGLE setting
1) While on the System Setup Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the NAV ANGLE field in the Display Units Box.
3) Turn the small FMS Knob to select ‘MAGNETIC’ or ‘TRUE’.
4) Press the ENT Key. Press the CLR Key to cancel the action without changing the units.
AIRSPACE ALERTS
The Airspace Alerts Box allows the pilot to turn the controlled/special-use airspace message alerts on
or off. This does not affect the alerts listed on the Nearest Airspaces Page or the airspace boundaries
depicted on the MFD Navigation Map Page. It simply turns on/off the warning provided when the aircraft
is approaching or near an airspace.
Alerts for the following airspaces can be turned on/off in the Airspace Alerts Box:
• Class B/TMA
• Class C/TCA
• Class D
• Restricted
• MOA (Military)
• Other airspaces
An altitude buffer is also provided which “expands” the vertical range above or below an airspace. For
example, if the buffer is set at 500 feet, and the aircraft is more than 500 feet above/below an airspace, an
alert message will not be generated, but if the aircraft is less than 500 feet above/below an airspace and
projected to enter it, the pilot is notified with an alert message. The default setting for the altitude buffer
is 200 feet.
Changing the altitude buffer distance setting
1) While on the System Setup Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the altitude buffer field in the Airspace Alerts Box.
3) Turn the FMS Knobs to enter an altitude buffer value and press the ENT Key.
Turn an airspace alert on or off
1) While on the System Setup Page, press the FMS Knob momentarily to activate the flashing cursor.
2) Turn the large FMS Knob to highlight the desired field in the Airspace Alerts Box.
3) Turn the small FMS Knob clockwise to turn the airspace alert ON or counterclockwise to turn the alert OFF.