User Guide

Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang
190-00600-00 Rev. B
39
Hazard Avoidance
Ground Mapping
1) Select the MODE Softkey.
2) Select the GROUND Softkey to place the radar in Ground Map Mode.
3) Select the BACK Softkey.
4) Press the FMS Knob to activate the cursor.
5) Turn the large FMS Knob to place the cursor in the ‘TILT’ field.
6) Adjust the antenna tilt angle by turning the small FMS Knob to position the
ground returns as desired.
7) Press the FMS Knob to remove the cursor.
Ground Map
Mode Color
Intensity
BLACK 0 dB
LIGHT BLUE > 0 dB to < 9 dB
YELLOW 9 dB to < 18 dB
MAGENTA 18 dB to < 27 dB
BLUE 27 dB and greater
Sector Scan
1) While in the Horizontal Scan Mode, move the Joystick right or left to place
the Bearing Line in the desired position. The location of the Bearing Line
will become the center point of the Sector Scan.
2) Press the FMS Knob to display the cursor.
3) Turn the large FMS Knob to place the cursor in the SECTOR SCAN field.
4) Turn the small FMS Knob to select FULL, 60˚, 40˚, or 20˚ scan.
5) If desired, readjust the Bearing Line with the Joystick to change the center
of the Sector Scan.
6) Press the FMS Knob to remove the cursor.
Antenna Stabilization
1) To activate or deactivate the antenna stabilization, select the MODE Softkey.
2) Select the STAB ON Softkey to activate antenna stabilization or select the
STAB OFF Softkey to deactivate. The current stabilization condition is shown
in the upper right of the weather radar display.