Instruction Manual

Subwoofer Wiring

When connecting the subwoofer to your amplifier or source, observe the following considerations.

• Speaker wire is not included with the subwoofer. You should use 12AWG (3 through 4mm

) speaker wire to

connect the subwoofer to the amplifier or source.

• The leads on the subwoofer are terminated using male spade connectors. You should use female spade

connectors (not included) to connect the speaker wire to the speaker leads for the best connection.

• The subwoofer features a dual 2 Ohm voice coil that can be configured for 2.1 operation (two speakers and

one subwoofer) when connected to a Fusion stereo with DSP capability (Configuring the Subwoofer for 2.1

Operation, page6).

• You can use the following table to identify the polarity of the leads on the speaker.

White Positive (+)

Gray with a black stripe Negative (-)

NOTE: Gray and white with a black stripe wires are connected to jumper terminals on the back of the

subwoofer. These wires must remain connected to the jumper terminals for normal use (4 Ohm) and should

be disconnected only when configuring the speaker for 2.1 operation.

LED Wiring

NOTICE

Using certain LED colors on the speakers, such as red and green, may violate the laws, regulations, and

standards related to the use and/or operation of marine navigation lights. It is the user's responsibility to

comply with any such applicable laws, regulations, and standards. Garmin is not responsible for any fines,

penalties, citations, or damages that may be incurred due to any such lack of compliance.

It is recommended to install a Fusion RGB Wireless Remote Control module with these speakers to turn the

LEDs on and off, change the colors, and create lighting effects. See your Fusion dealer or garmin.com for more

information.

You should follow the instructions provided with the RGB Wireless Remote Control to connect the LED wires

from the speakers to the remote control receiver module and to connect the receiver to power.

If you choose not to install the remote control, you can set the static color of the LEDs by connecting

combinations of the LED wires directly to the power source (Connecting the LED Wires, page5).