Owner's Manual

Introduction
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Setting Up the System
You must set up the handheld device and the dog collar device
before you can use the devices.
1
Install batteries in the handheld device (Installing Batteries).
2
Charge the dog collar device (Charging the Dog Collar
Device).
3
Turn on the devices (Turning On the Devices).
4
If necessary, add the dog collar device to the handheld
device (Adding a Dog).
5
Acquire satellite signals (Acquiring Satellite Signals).
Device Overviews
Astro 320 Handheld Device
NOTICE
Avoid using a high-powered radio (greater than 5 watts) in close
proximity to the handheld device. It may cause irreversible
damage to the handheld device.
À
GPS antenna
Á
VHF antenna
Â
Power key
Ã
Display
Ä
Keypad
Å
USB port (under weather cap)
Æ
microSD™ card slot (under battery door)
Ç
Mounting spine
È
Battery cover D-ring
Keypad
IN Select to zoom in on the map.
OUT Select to zoom out on the map.
MAP Select to view the map.
MENU Select to open the menu for the active page.
Select twice to open the main menu.
ENTER Select to select options and acknowledge messages.
BACK Select to cancel data entry or return to the previous menu
or page.
MARK Select to mark your current location.
DOG Select to view the dog tracking page.
Select to view or scroll through options and to move the
map pointer.
Locking the Keypad
1
Select .
2
Select OUT.
T5 Dog Collar Device
À
VHF antenna
Á
Collar
Â
GPS antenna
Ã
Power key
Installing Batteries
The handheld device operates on two AA batteries (not
included). Use NiMH or lithium batteries for best results.
1
Turn the D-ring counter-clockwise, and pull up to remove the
cover.
2
Insert two AA batteries, observing polarity.
Introduction 1