User Manual

Varia RCT715 Device Status LED
LED State Status
Flashing purple The device is in active pairing mode.
Flashing blue
The device is in smart mode and can be controlled by a paired compatible
Garmin device.
Flashing green The device is charging.
Solid green The device is fully charged.
Flashing yellow The device is in lock mode.
Flashing red
The device has approximately 60 or fewer minutes of battery life
remaining.
Solid red An error occurred. You may need to restart the device.
Varia RCT715 Camera Status LED
LED State Status
Solid red The device is recording video.
Flashing red The device is saving a video or photo.
Alternating red and yellow flashes The memory card is low on space.
Flashing yellow There is a problem with the memory card.
Solid green
The memory card is being formatted.
The device is in mass storage mode.
Flashing green
The device is powering on.
The memory card is being accessed.
Flashing blue The device is in Wi‑Fi
®
sharing mode.
Tail Light Modes and Intensity
You can switch the Varia RCT715 tail light modes by pressing the device button (Device Overview, page 4).
Mode Light Intensity Default Flash Behavior
Flash Behavior when
Vehicle Approaches
Solid (default) High None Light flashes
Peloton (group ride) Moderate None Light flashes softly
Night Flash High Slow Light flashes quickly
Day Flash Maximum Occasional Light flashes quickly
Standby Off None
The device does not
detect vehicles
Turning Off the Device
Hold the device button for 2 seconds (Device Overview, page 4).
NOTE: You can also hold both buttons for 4 seconds to lock the device, preventing it from turning on.
Introduction 5