User Manual
Table Of Contents
- Table of Contents
- Introduction
- Training
- Ride Data
- Device Information
- Other Compatible Devices
- Appendix
Installing the Pedals
This procedure is for any Rally 200 system and uses images of the Rally RS pedals. The installation for any Rally
100 system is the same, but the power sensor components are in the left pedal only. For more information, see
About the Rally 100 System, page 7.
1 Install the right pedal first.
2 Apply a thin layer of grease on the pedal spindle threads.
3 Insert the spindle into the crank arm.
4 Hand tighten the spindle.
5 Use the pedal wrench to tighten the spindle.
NOTE: Garmin
®
recommends torque of 25 lbf-ft. (34 N-m).
6 Repeat steps 2 through 5 to install the left pedal.
NOTE: The left pedal spindle has a left-handed (reverse) thread.
2 Introduction