User Manual
Table Of Contents
- Table of Contents
- Introduction
- Training
- Ride Data
- Device Information
- Other Compatible Devices
- Appendix
Installing the Shoe Cleats for Rally XC
NOTE: The left and right cleats are the same.
1 Inside your shoe, lift the insole and insert the 2-hole cleat mount and the insole washer .
2 Apply a thin layer of grease on the cleat bolt threads.
3 Align the cleat , washer , and bolts .
4 Use a 4 mm hex key to loosely attach each bolt to the sole of the shoe.
5 Adjust the cleat to the shoe in your preferred position.
This can be adjusted after a trial ride.
6 Tighten the cleat firmly to the shoe.
NOTE: Garmin recommends a torque of 4 to 6 lbf-ft. (5 to 8 N-m).
Adjusting the Release Tension
NOTICE
Do not overtighten the release tension screw on the bottom of the pedal. The release tension should be
adjusted equally for both pedals.
The Rally XC pedal tension must be set on both sides of both pedals.
Use a 3 mm hex key to adjust the release tension.
6 Introduction