Owner's Manual

Appendix
Battery Information
Battery Warnings
Your GPS device uses a user-replaceable sealed lead acid battery. If these
guidelines are not followed, the battery may experience a shortened life span
or may present a risk of damage to the device, fire, chemical burn, electrolyte
leak, and/or bodily injury.
.&. WARNING
• When storing the battery for an extended time, store within the following
temperature range: from so F to 104°F (from -1So C to 40° C).
• Do not operate the battery outside of the following temperature range: from
so F to 122° F (from -1So C to sao C).
• Do not place the battery near objects that may cause sparks, flames, or
heat.
• Do not incinerate the battery.
• Keep the battery tightly closed.
• Do not use a sharp object to remove the battery.
• Do not disassemble, puncture, or damage the battery.
• Do not swallow, touch, or inhale the contents of an open battery. Avoid
contact with internal acid. Contact with internal acid may cause irritation or
severe burns. Irritation may occur to the eyes, respiratory system, and
skin. Flush with water at once if contact is made with acid.
• Do not submerge the battery and avoid contact with water.
• Do not short the battery terminals.
• Do not drop or throw the battery.
• Keep the battery away from children.
• Only replace the battery with the correct replacement battery. Using
another battery presents a risk of fire or explosion of the device or charger.
• Only charge the battery with the included charger.
• Do not charge the battery in an unventilated area.
• Store in a cool, dry, and well-ventilated area.
• Do not charge the battery in a gas-tight container.
• Do not leave the device exposed to a heat source or in a high-temperature
location, such as in the sun in an unattended vehicle. To prevent damage,
remove the device from the vehicle or store it out of direct sunlight.
• Do not use organic solvents or other cleaners other than recommended
chemical cleaners on the battery.
• Contact your local waste disposal department to dispose of the battery in
accordance with applicable local laws and regulations.
Charging the Battery
.&. CAUTION
Ensure that you connect the correct connector to the correct battery terminal.
Damage to the battery, device, or bodily harm may occur if the device is
improperly connected to the battery.
Before you can charge the battery using the charger, you must disconnect the
device power cable from the positive and negative terminals on the battery.
The battery is rechargeable and can be charged by connecting the battery to a
wall charger.
1 Connect the positive connector on the wall charger onto the positive
terminal on the battery.
2 Slide the negative connector on the wall charger onto the negative terminal
on the battery.
3 Connect the wall charger to the wall outlet.
Battery Tips
• The life expectancy of a sealed lead acid battery can be extended by
recharging often and not completely discharging the battery.
• Sealed lead acid batteries slowly lose their charge while in storage . For
best results, charge the battery prior to use.
Instru c tions d'installation
When used in cold temperatures, sealed lead acid batteries do not hold the
charge as long as in warmer temperatures.
• To avoid spilling the internal acid, keep the battery in the upright position.
• Sealed lead acid batteries are completely recyclable.
Specifications
r
Battery type
Battery shelf life after charging
Battery operating temperature range
I Sealed lead acid
---+--c:-- 1 m- onth: 92%
3 months: 90%
6 months: 80%
From 5o F to 122° F (from
-W Cto50o C)
From 5° F to 104° F (fro:J
-15° C to 40° C)
--+=--
From 5° F to 104° F (from
Physical size (assembled kit with device)
1
-15° C to 40° C)
L x W x H: 10.629 in. x
10.629 in. x 11.02 in. (270
mm x 270 mm x 280 mm)
______:____j
Weight (unassembled kit with device)
8.498 lb. (3855 g) ___j
Support portable Instructions d'installation
Mise en route
.&. AVERTISSEMENT
Consultez le guide Informations importantes sur /e produit et Ia securite inclus
dans l'emballage du produit pour prendre connaissance des avertissements et
autres informations sur le produit.
Assemblage du support de montage
Pour pouvoir assembler le support de montage, vous devez disposer d'un
tournevis cruciforme.
lnserez Ia poignee <D dans les deux emplacements situes sur le support
portable@.
2 Fixez Ia poignee au support portable a l'aide de deux vis M4xQ,?x40 ® et
de deux ecrous M4x7 mm @.
3 lnstallez le sondeur ou traceur sur le support portable.
Veuillez vous referer aux instructions d'installation de votre sondeur ou
traceur.
Sonde
La sonde peut etre instalh§e de deux fa9ons. Vous pouvez installer Ia sonde a
l'aide du support a ventouse inclus pour Ia fixer sur les cotes ou le dessous de
votre bateau. Vous pouvez egalement utiliser Ia sonde avec le flotteur fourni
pour pecher so us Ia glace ou depuis un ponton.
Installation du f/otteur de sonde
1 Tout en tenant Ia sonde d'une main, prenez une longueur du cable de Ia
sonde et faites une boucle.
2 lnserez Ia boucle dans l'une des extremites du flotteur jusqu'a ce qu'elle
ressorte par l'autre extremite.
3