Owner's Manual

Installing the Transducer on a Trolling Motor Barrel
Labels identifying the parts bags required for this procedure:
NOTICE
You must secure the transducer cable to the shaft or other secure location during installation. Damage to the
transducer cable wires or cable jacket can cause transducer failure.
1 Remove the rubber liner from parts bag .
2 Remove the hose clamp and trolling motor barrel mount from parts bag .
3 Insert the hose clamp through the slot on the trolling motor mount until equal lengths extend on both
sides of the mount.
4 Place the rubber liner against the trolling motor barrel where you plan to secure the mount.
5 Secure the hose clamp around the trolling motor barrel using a flat screwdriver or 8 mm wrench or socket.
6 Remove the knob from parts bag .
7 Attach the transducer to the mount using the knob , and tighten the knob by hand.
NOTE: You can secure the transducer to the mount using the included low-profile hardware instead of the
knob if you do not plan to switch transducer modes frequently during use (Installing the Transducer Using
Low Profile Mounting Hardware, page 14).
8 Secure the transducer cable to the motor shaft or other secure location.
9 Route the transducer cable to the installation location of the sonar module while taking these precautions.
• You must route the cable so that it does not come in contact with the propeller when the trolling motor is
operating.
• You should not route the cable close to electrical wires or other sources of electrical interference.
• You must route the cable so it is not pinched when the trolling motor is deployed or stowed.
NOTE: If necessary, for extra cable length you can connect an optional extension cable, available at
buy.garmin.com or from your Garmin dealer.
8