Owner's Manual

Installing the Transducer on the Perspective Mode Mount
Labels identifying the parts bags required for this procedure:
NOTICE
You must secure the transducer cable to the shaft or other secure location during installation. Damage to the
transducer cable wire or the cable jacket can cause transducer failure.
NOTE: To avoid obstructions in the sonar image, you should mount the transducer on the shaft as far from the
motor as possible.
1 Remove the perspective mode extension arm, the front half of the mounting bracket, and the short knob from
parts bag
2 Remove the back half of the mounting bracket and four screws from parts bag .
3 Remove the long knob from parts bag .
4 If the trolling motor shaft is equal to or less than 25 mm (1 in.) in diameter, remove the rubber liner from
parts bag .
5 Identify the arrow on the front half of the mounting bracket to ensure that you orient the bracket with the
wide end of the slant at the top when you attach the bracket to the trolling motor shaft.
NOTE: The perspective mode bracket has an 11-degree angle to allow the extension arm to transition
between all three sonar views.
6 If you are installing the transducer on a trolling motor shaft equal to or less than 25 mm (1 in.) in diameter,
wrap the rubber liner around the shaft in the location you want to install the mount.
4