Owner's Manual
Table Of Contents
- Important Safety Information
- Tools Needed
- Mounting Considerations
- Installing the Transducer on the Perspective Mode Mount
- Installing the Transducer on a Trolling Motor Barrel
- Installing the Transducer on the Trolling Motor Shaft
- Installing the Transducer on a Pole
- Installing the Transducer Using Low Profile Mounting Hardware
- Mounting the GLS 10 Black Box Device
- Transducer Settings and Operation
- Specifications
Trolling Motor Shaft Mount Orientation
The orientation angle depends on which side of the trolling motor shaft you mount the bracket on, and your
desired field of view.
When installing the transducer using the recommended adjustment knob, no tools are necessary to change the
orientation from forward to downward, or vice versa. You must loosen the knob to change the orientation and
tighten it to set the orientation.
NOTE: You should align the marks as shown on the transducer and mount to verify the appropriate orientation
before tightening the knob.
Port side, downward view
Port side, forward view
Starboard side, downward view
Starboard side, forward view
12