Owner's Manual

NOTE: The rubber liner is not needed when installing the transducer on a trolling motor with a shaft diameter
larger than 25 mm (1 in.).
6 Place the shaft-mount bracket around the rubber liner on the trolling motor shaft.
7 Insert the screws into the shaft mount bracket and secure them using the M5 hex wrench in parts bag .
8 (Optional) Transition the trolling motor from the deployed to the stowed position and back again to test the
location of the mounting bracket and make any adjustments as needed.
9 Remove the knob from parts bag .
10 Attach the transducer to the mount using the knob , and tighten the knob by hand.
NOTE: You can secure the transducer to the mount using the included low-profile hardware instead of the
knob if you do not plan to switch transducer modes frequently during use (Installing the Transducer Using
Low Profile Mounting Hardware, page 14).
11 Secure the transducer cable to the motor shaft or other secure location.
12 Route the transducer cable to the installation location of the sonar module while taking these precautions.
• You must route the cable so that it does not come in contact with the propeller when the trolling motor is
operating.
• You should not route the cable close to electrical wires or other sources of electrical interference.
• You must route the cable so it is not pinched when the trolling motor is deployed or stowed.
NOTE: If necessary, for extra cable length you can connect an optional extension cable, available at
buy.garmin.com or from your Garmin dealer.
13 Position the transducer to your desired angle, and tighten the knob (Installing the Transducer on the Trolling
Motor Shaft, page 10).
11