Owner's Manual

Innovation, Science and Economic Development Canada
Compliance
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device
must accept any interference, including interference that
may cause undesired operation of the device.
Radio Frequency Radiation Exposure
This device is a mobile transmitter and receiver that uses
an internal antenna to send and receive low levels of radio
frequency (RF) energy for data communications. The
device emits RF energy below the published limits when
operating in its maximum output power mode and when
used with Garmin authorized accessories. To comply with
RF exposure compliance requirements, the device should
be installed and operated with a minimum of 20 cm
(7.87 in.) between the device and your body. The device
should not be used in other configurations. This device
must not be co-located or operated in conjunction with
any other transmitter or antenna.
FCC Compliance
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and may cause
harmful interference to radio communications if not
installed and used in accordance with the instructions.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This product does not contain any user-serviceable parts.
Repairs should only be made by an authorized Garmin
service center. Unauthorized repairs or modifications
could result in permanent damage to the equipment, and
void your warranty and your authority to operate this
device under Part 15 regulations.
VHF Radio Information
This product may be used only on specific radio
frequencies, which vary depending on the country of use.
The device allows the user to install a different antenna.
Changing the antenna can result in improved radio
performance and higher radiated power. You must not
use the device with a third party antenna or an antenna
not approved by Garmin.
Map Data Information
Garmin uses a combination of governmental and private
data sources. Virtually all data sources contain some
inaccurate or incomplete data. In some countries,
complete and accurate map information is either not
available or is prohibitively expensive.
5