Owner's Manual
Table Of Contents
- Owner’s Manual
- Table of Contents
- Getting Started
- Installation
- Off-Road Navigation Features
- Using the Map
- Using the Apps
- Live Services, Traffic, and Smartphone Features
- Bluetooth Feature Status Icons
- Pairing Your Phone and Headset
- Smart Notifications
- Hands-Free Calling
- Setting Up Bluetooth Features for Your Apple® Device
- Setting Up Bluetooth Features for Your Smartphone with Android™
- Enabling or Disabling Bluetooth Features for Your Headset
- Disconnecting a Bluetooth Device
- Deleting a Paired Phone
- Street Navigation
- Finding and Saving Locations
- Finding a Location Using the Search Bar
- Points of Interest
- Finding a Location by Category
- Viewing Your Garmin Explore Points of Interest
- Location Search Results
- Changing the Search Area
- Finding Parking Near Your Current Location
- Finding Parking Near a Specified Location
- Search Tools
- Finding HISTORY Points of Interest
- Finding National Parks
- Finding Ultimate Campgrounds Points of Interest
- Finding iOverlander™ Points of Interest
- Finding Powersport Points of Interest
- Tripadvisor
- Viewing Recently Found Locations
- Viewing Current Location Information
- Adding a Shortcut
- Saving Locations
- Rider Awareness Features and Alerts
- Settings
- Device Information
- Device Maintenance
- Troubleshooting
- My device is not acquiring satellite signals
- My battery does not stay charged for very long
- My device does not connect to my phone
- My device does not appear as a removable drive on my computer
- My device does not appear as a portable device on my computer
- My device does not appear as either a portable device or a removable drive or volume on my computer
- Appendix
- Garmin PowerSwitch
- Wireless Cameras
- Installing a Memory Card for Maps and Data
- Data Management
- Viewing GPS Signal Status
- Purchasing Additional Maps
- Index
- Tread Installation Instructions
- Important Safety and Product Information
Attaching the Power Cables to the Mount
1 Thread the power cable connector through the opening in the mount.
2 Pull the cable back until it is snug.
3 Screw the black screw into the back of the mount to hold the cable in place.
NOTE: An additional replacement screw is included in the box.
Attaching the Base Plate to the Mount
NOTICE
Direct, sustained contact with the base plate, or any other part of the vehicle, may damage the mount over time.
To prevent this kind of damage, you must place the mounting spacers between the mount and base plate, and
make sure that no part of the device or mount touches the vehicle.
1 Thread the M4 x 20 mm panhead screws through the washers , cradle, bushings, spacers , and
base plate .
2 Tighten the nuts to secure the base plate.
Installation Instructions 3