Owner's Manual
Table Of Contents
- Owners Manual
- Reset
- Table of Contents
- Introduction
- The Varia Taillight and Your Edge 1000
- Device Information
- Troubleshooting
- Support and Updates
- The taillight disconnects from the Edge device
- The taillight disconnects from the Varia RDU Device
- The taillight is not responding
- The status LED turns red while charging
- Thermal Safety Shutdown
- Pairing the Taillight with the RDU Device
- Resetting the Device
- Replacement O-rings
- Getting More Information
- Index
- Instructions
- Warranty
•
If
the
seat
post
diameter
is
from
31
to
31.8
mm,
do
not
use
a
rubber
pad.
3
Place
the
seat-post
connector
around
the
rubber
pad.
NOTE:
You
should
align
the
contours
on
the
rubber
pad
with
the
grooves
on
the
inside
of
the
seat-post
connector.
4
Replace
and
tighten
the
screw.
NOTE:
Garmin
recommends
a
torque
specification
of
7
lbf-in.
(0.8
N-m).
You
should
check
the
tightness
of
the
screw
periodically.
5
Align
the
tabs
on
the
back
of
the
device
with
the
seat-post
mount
notches@.
6
Press
down
slightly
and
turn
the
device
clockwise
until
it
locks
into
place.
Turning
On
the
Varia
RTL
Device
Hold
the
device
key
CD.
-
--
- -
Instructions
5