User guide

Safety Requirements RTCSmp Built-In Temperature Controlled Hold-Line
Part # 4532288 Rev 3 (6/11/14) 5
o Do not place credit cards, phone cards, tapes, or any objects sensitive to magnetism on the cooking
surface.
o Do not place plastic vessels and aluminum objects such as aluminum foil on the glass-top.
 Persons with a cardiac pacemaker should consult their doctor whether they are safe near an induction unit.
 If the power cord is damaged, have it replaced immediately by an approved service technician.
 Ensure liquid cannot enter into the induction unit. Do not let water or food overflow the cooking area. Do not
use hoses to clean or power wash the induction unit or its vicinity.
 The induction unit has an internal air-cooling system. Do not block the air intake and exhaust openings with
objects such as cleaning cloths or containers. Any obstruction to the air intake and exhaust could cause the
unit to overheat and to switch off.
 Switch the unit OFF if you take the cookware away for a while. This will prevent the heating process to start
automatically and unintentionally when a pan is placed back on the heating area. If any person needs to use
the induction unit, he/she will have to turn the unit ON intentionally.
 A dirty air filter blocks the fresh air inlet. The Air Inlet Filter should be cleaned at least once a week (dish-
washer safe) or as often as necessary. Wipe the filter dry before putting it back into the unit.
 Remove immediately any food residuals from the glass-top.
 Use only induction suitable cookware with proper size and made of proper material. The induction suitable
cookware should also be in good condition without any uneven, arched or partially detached bottoms.
 Protect the induction unit from steam if the unit is placed next to high steam emitting equipment such as
pasta cookers, steamers, and water bath.
1.3 Improper Use of the Equipment
The reliability of the induction unit can only be guaranteed when it is used properly. The induction unit must
always be operated within the limits provided in the technical specifications. Please refer to section 9 Important
Rules of using induction equipment.
1.4 Unauthorized Modification and Use of Spare Parts
Please contact the manufacturer if you intend to make any changes on the induction unit. For safety reasons,
always use genuine parts and accessories approved by Garland. Any unauthorized modification as well as any
installation of unapproved components will void all warranty. See Warranty, p.2.
1.5 Pan Detection
Energy is transferred to cookware when the induction system detects a suitable pan on the heating area. The
digital display signals to communicate the Pan Detection process.
 When the unit is ON without any pan on the hob, the display shows the current temperature without a
dot; the unit is in pan detection mode.
 As soon as a pan is put on the hob, the heating process is engaged and the display shows the current
temperature with a dot blinking.
 However, if the unit is not detecting any pan, the current temperature is shown without a dot.
NOTE: Pan with a bottom diameter smaller than 5” (12 cm) is not detected by the system.