User guide

Installation RTCSmp Built-In Temperature Controlled Hold-Line

Part # 4532288 Rev 3 (6/11/14) 15

4.5.2 Front-Mount

To mount the control unit

onto the front of the panel:

1. Drill holes and make the

cut-out using the

dimensions and the actual

unit provided.

2. Secure the control unit to

the panel with fasteners.

Illustration: Measurements in mm

and [inch].

4.5.3 Back-Mount

NOTE For this type of installation, the maximum thickness of the panel must not exceed 3mm or 12 gauge.

This restriction ensures a proper grip on the knob.

To mount the control unit

from the back of the panel:

1. Drill holes on the panel using

the dimensions provided.

2. Remove the plastic knob

from the control unit and

attach the control unit to the

panel with fasteners as

shown. NOTE: DO NOT

remove or loosen any

screws on the control unit.

Illustration: Measurements in mm

and [inch].

Front Panel

12 [ .474]

10.11 [ .398]

maximum

3 [0.12]