Instructions / Assembly

12
CLEANINGFROMOUTSIDEWITHACORDLESSDRILL

Cleaning From Outside:
1. Thread 4” Auger Brush
onto flexible rods.
2. With the vacuum/blower running, go to the
exterior and begin spinning the rods & brush
into the vent.
Important:
a) Be sure the clutch is set on in the mid range
(or lower). (See drill operation)
b) ALWAYSspinthedrillinthe“CLOCKWISE”direction.
c) Use duct tape on all Brush/Rod connec
tions.
3. Connect one rod at a time until yo
u reach the opposite end.
Note: If your vent is longer than the included length of rods, finish cleaning from the
opposite end. (Included rods will clean up to 18’ of venting when used
from each end.
4. It is recommended that you spin the drill at a
moderate to high speed while using a back &
forth motion.
5. If the brush binds up, stop immediately.
ImportantNote: Use caution and take your time
to avoid breaking the rods or damaging the vent.

NeverForcetheRods!
AlwaysSpinDrillClockwise!

Step11