Specification

SK 800

• SEALS AND PROTECTS ROOFS • STA-KLEEN BRIGHTER LASTING FINISH
• EXPANDS AND CONTRACTS UP TO 350% • URETHANIZED FOR LONGEST LIFE
•
HELPS LOWER COOLING COSTS • INSUL-THERM BLOCKS HEAT GAIN
6&22/
@
73*422/.1,"-.6**4&0.(/&5620*4.(

22+2&6.1,is the next generation in solar protection and cooling technology.
P
roduct enhanced with urethane for ultimate performance. Industry rated #1 in
solar reflectance, this coating blocks heat-causing sunlight more than any other.
6&22/gives longest protection, ultimate flexibility, and a watertight seal.
S
ave money on your cooling expenses with the highest rated coating in the
industry.

 Pressure washing entire surface is recommended for best
r
esults (use only a wide fan spray tip). All surfaces must be dry and free of dust,
dirt, oil, loose granules, gravel or peeling paint and all other foreign matter.
Roofs must have proper ventilation. Roofs must have proper drainage and not
h
old “ponding water”. Rusty metal must be cleaned with a wire brush and
primed with a metal primer/sealer before application of this product. Repair all
leaks and cracks with 6&22/  "-.6* 22+ &6(- &1) 1.8*45&/

&6(-.1,&'4.( .n accordance with product instructions.Surfaces previously
coated with aluminum, asphalt or tar should be allowed to cure for a minimum
of one summer season prior to coating with this product. Surfaces with mildew
growth or stains must be cleaned with a bleach solution (2 parts water to one
part bleach). Be certain all surfaces are thoroughly rinsed and dry prior to
applying coating. Do Not Thin.

Surface and air temperatures must be a minimum of 65°F and
rising. DO NOT apply if heavy dew or rain is expected within 24-48 hours. Apply
on clear, sunny day in morning hours with a professional airless paint sprayer
or a 3/4" nap exterior paint roller. First, apply one coat over all seams and joints.
Allow to cure for one hour or until dry, then apply two (2) uniform coats over
entire surface, avoiding excessive rolling. Two full coats are needed for all
applications. Apply second coat perpendicular to first coat. Allow at least 24
hours between coats and 24-48 hours for full curing. DO NOT apply to flat
surfaces, poor drainage areas, or where ponding water will exist.
!  Approximately 50-75 sq. ft. per gal. per coat. Total
coverage for two (2) coat application is 25-35 sq. ft. per gallon.
If roof becomes hot (over 100° F) during application, lightly mist roof
surface with water spray to prevent coating from drying too fast. Remove any
excess or puddling water prior to coating. If roof surfaces become soiled as they
age, due to the elements, Elastomeric can be cleaned with a mild water and
bleach solution. Excess scrubbing should be avoided. If coloring is desired, a
typical addition of 3-4 ounces per gallon of universal colorant can be added,
which will result in light pastel colors. Note: Color tinting will disclaim warranty.
 Clean tools with soap and water.
  For exterior use only. DO NOT allow product to freeze.
Protective clothing and eyewear should be used during application of these
products. When transporting this product, ensure that lid is tight and pail secure
and upright. DO NOT allow pail to tumble as this may cause lid to loosen and
leakage to occur. Do not transport on passenger seats or inside the passenger
compartment of any vehicle. Store product in the cargo area of vehicle, and
secure over protective cloths to prevent damage due to accidental spills. For
longest life, store in controlled environment, 35°F-80°F. DO NOT store in direct
sunlight. DO NOT store at temperatures above 110°F. Close container after use.
DO NOT reuse empty containers. Not intended for use on EPDM, Hypalon,
PVC, or TPO. Perform Peel Adhesion Test (ASTM D903-98) before applying to
any single ply roofing surface. Do not use in drinking water or food systems.
  "" " 
! 
 May cause eye, skin and respiratory irritation. Avoid prolonged
breathing of vapor or spray mist. 1&5*+Contact a physician
immediately.   Wash thoroughly with soap and water. $
Flush thoroughly with clean, room temperature water and contact
a physician immediately.
"&41.1,BIf you scrape, sand or remove old paint, you may release lead dust.
LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-
approved respirator to control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to protect yourself and
your family by contacting the National Lead Information Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead <http://www.epa.gov/lead>.
?"This product contains chemicals known to the
State of California to cause cancer, birth defects or other reproductive harm.
Use proper protection and adequate ventilation, when using product.
!less than 40 g/L (less water & exempt)
Water/Agua CAS # 7732-18-5
Latex Polymer/Polímero de látex CAS # Mixture
Titanium/Titanio CAS # 13463-67-7
Calcium Carbonate/Carbonato de calcio CAS # 1317-65-3
Product is asbestos free.
"$   6&22/
@
 73*422/.1, "-.6*
*4&0.(/&5620*4.(22+2&6.1,is guaranteed to form a protective coating
to your roof, for a period of fifteen (15) years from the date of purchase. This
warranty is only applicable when this product is applied according to our
directions, in two coats, and used with other Sta-Kool products. This warranty
does not cover flat roofs, or poor drainage surfaces where ponding water
exists. All surfaces must maintain a minimum slope of 1" per foot (5°), to be
eligible for warranty. If the coating does not perform as stated during the
guarantee period, we will provide, with sales receipt, the original purchaser
with replacement coating to repair the affected part of the roof. Failures due to
acts of God, fire, structural defects or causes beyond our control are excluded
from this guarantee. The manufacturer is not responsible for any labor, property
or other consequential damages or costs incurred in the original or any
replacement application. Except as stated above, we make no warranties or
guarantees, expressed or implied, and none should be inferred.
Gardner-Gibson, Inc. • P.O. Box 5449 • Tampa, Florida 33675-5449
Phone: [phone] • Fax [phone] • www.gardner-gibson.com

*(-2 *1 
See MSDS for more info
Approx. Shipping Weights: (Note: All approx. weights include container.)
5 gallons (18.9L) 60 lbs.
55 drums (208.2L) 700 lbs.
15 YR SUPERCOOLING CERAMIC
Data Sheet
©2008 Gardner-Gibson, Inc.
Manufactured by / Fabricado por: Gardner-Gibson, Inc.,
P.O. Box 5449 • Tampa, FL 33675
Weight Per Gallon 12.00 ± .30 lbs.
Solids by Weight, % 63% ± 3%
Elongation (ASTM D-562) 200% - 300%
Tensile Strength (ASTM D-2370) 200 - 400 psi.
Reflectivity (ASTM C-523) .90 - .94
Adhesion to Polyurethane Foam Excellent
Combustible Solvents Propylene Glycol
Consistency 110-140 Ku
Cure Time (50% Relative Humidity, 70˚F) 1 hour
Full Cure (50% Relative Humidity, 70˚F) 72 hours
Application Temperatures 65˚F and rising
Flammability None
Clean-up Tools Water
TYPICAL PHYSICAL & PERFORMANCE CHARACTERISTICS