SDS
Page 3 of 7
Airborne exposures to hazardous dusts or mists may be generated by spraying, sanding or grinding.
SeeSection11forToxicologicalInformation.
Section 4 - First Aid Measures
Inhalation
‐
Remove to fresh air. Call a physician or poison control center if you fell unwell. If
not breathing, give artificial respiration.
Skin
‐
Wash the contaminated area of body with soap and fresh water. Remove
contaminated clothing and shoes. Get medical attention if symptoms occur.
Eye
‐
Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove
contact lenses, after the first five minutes, then continue rinsing eye. If eye
irritation persists: Get medical advice/attention.
Ingestion
‐
Call a physician or poison control center immediately. Do not give anything by
mouth to an unconscious person. Do NOT induce vomiting.
SeeSection2forPotentialHealthEffects.
Section 5 - Fire Fighting Measures
Extinguishing Media
‐
SMALL FIRES: Dry chemical, CO2, water spray or regular foam.
Unsuitable Extinguishing
Media
‐
No data available
Firefighting Procedures
‐
Keep unauthorized personnel away. Stay upwind. Fire fighters should wear
complete protective clothing including self-contained breathing apparatus.
Unusual Fire and Explosion
Hazards
‐
Some of these materials may burn, but do not readily ignite. May release irritating
or toxic gases, fumes, or vapors.
Hazardous Combustion
Products
‐
Carbon monoxide, carbon dioxide, hydrocarbons.
Protection of Firefighters
‐
Wear positive pressure self-contained breathing apparatus (SCBA).
Flash Point
‐
460°F(238°C)
Section 6 - Accidental Release Measures
Personal Precautions
‐
Do not touch damaged containers or spilled material unless wearing appropriate
protective clothing. If you have not donned special protective clothing approved for
this material, do not participate in the cleanup. Ventilate enclosed areas.
Emergency Procedures
‐
Stop leak if you can do it without risk Isolate the area and contain the spilled
material. Persons not wearing the appropriate PPE should be removed from the
area until the spill is cleaned up
Environmental Precautions
‐
Avoid run off to waterways and sewers. Do NOT wash away into sewer.
Containment/Clean-up
Measures
‐
Use appropriate Personal Protective Equipment (PPE) Contain and/or absorb spill
with inert material (e.g. sand, vermiculite), then place in suitable container.
Prohibited Materials
‐
Avoid contact with strong oxidizing agents and acids.
Section 7 - Handling and Storage
Handling
‐
Keep containers tightly closed when not in use. Use only with adequate ventilation.
Storage
‐
Keep only in the original container/package in a cool well-ventilated place. Keep
away from fire. Keep container closed when not in use.
Special Packaging Materials
‐
No data available
Incompatible Materials or
Ignition Sources
‐
Avoid contact with strong oxidizing agents and acids.







