SDS

SAFETY DATA SHEET
Gardner Blacktop Crack & Joint Filler - Black Page 3 of 5
SECTION 9 – PHYSICAL and CHEMICAL PROPERTIES
Appearance (Physical state, color):
Thick fluid paste, black
Odor:
Mild, acrylic-like
Odor Threshold:
No information is available.
pH:
7.5 – 8.5
Melting point:
No data is available.
Initial Boiling Point & Boiling Range:
100 °C to 244 °C (212 °F to 471 °F)
Flash Point:
>94 °C (>201 °F)
Evaporation Rate:
Slower than Ether
Flammability:
Nonflammable
Upper/Lower Flammability Limits:
No data is available.
Vapor Pressure:
17.5 mm Hg @ 20 °C (68 °F)
Vapor Density:
Heavier than air
Density:
1.68 g/cm
3
(14.0 Lbs/gal) 21 °C (70 °F)
Solubility (in water):
Dispersible in water
Partition coefficient (n-octanol/water):
No data is available.
Auto-ignition temperature:
No data is available.
Decomposition temperature:
>250 °C (482 °F)
Viscosity (Brookfield RV, 5 rpm):
300,000 cP ±90,000 @ 21 °C (70 °F)
SECTION 10 – STABILITY and REACTIVITY
Reactivity: No hazardous reactions if stored and handled as prescribed.
Chemical Stability: The product is stable if stored and handled as prescribed.
Hazardous decomposition products: Carbon dioxide, carbon monoxide, and hydrocarbons.
Hazardous polymerization: Will not occur. The product is chemically stable.
SECTION 11 – TOXICOLOGICAL INFORMATION
Primary routes of exposure: Routes of entry for the product into the human body are
accidental ingestion, accidental eye contact, and prolonged skin contact. Inhalation of the vapor
released from the product as it dries is dependent upon the absence of air flow during use of the
product.
Acute Toxicity/Effects:
EYES: Direct contact may cause irritation.
SKIN: May cause irritation to sensitive skin or open wounds.
INHALATION: May cause irritation to respiratory passages.
INGESTION: May cause nausea/gastrointestinal distress.
No ingredient in this product is an IARC, NTP or OSHA listed carcinogen.