TDS
Gardner
®
FIBER COAT+ is a premium rubberized asphalt coating for renewing worn out roofs and foundations. This unique
blend of asphalt and rubber provides great strength and exibility for lasting protection to roofs, masonry surfaces and metal.
Fiber reinforced coating will bridge small cracks to provide a crack resistant layer of protection. Ideal to use as a base coat before
applying reective roof coatings. For exterior foundations, Fiber Coat+ dampproofs and preserves below grade surfaces including
masonry, wood and metal. Can be used on a variety of surfaces and is low odor and water cleanup.
• Ideal for Coating Worn Roofs
• Tough Flexible Finish Resists Cracking
• Heavy Duty Coating for Roofs and Foundations
• Fast Dry/Low Tack Formula
• Low Odor, Water Cleanup
www.gardner-gibson.com
Gardner-Gibson • P.O. Box 5449 • Tampa, Florida 33675-5449
Phone: (813) 248-2101
PREPARATION: Surfaces must be cleaned, free of dust, surface rust and loose material. If possible, power wash
surface before applying coating. Use brush or 3/4” nap roller to spread coating across roof. Wear protective clothing.
Don’t apply to wet surfaces.
APPLICATION: Apply on a clear warm day with no rain expected for 24 hours. Apply when surface temperatures are
between 60° and 120 °F. MIXING MAY BE REQUIRED TO ENSURE PRODUCT UNIFORMITY. DO NOT APPLY DIRECT
HEAT/FLAMES OR THIN. Allow product to cure a minimum of 15 days prior to application of reective coating, if used
as a roof coating.
COVERAGE RATE: Covers approximately 50 sq. ft. per gal/per coat. Two coats are recommended.
PRECAUTIONS: Protective clothing and eyewear should be used during application of these products. When
transporting this product, ensure that lid is tight and pail secure and upright. Do not allow pail to tumble as this may
cause lid to loosen and leakage to occur. Do not transport on passenger seats or inside the passenger compartment
of any vehicle. Store product in the cargo area of vehicle, and secure over protective cloths to prevent damage due to
accidental spills. Do not store at temperatures above 100 °F. Do not use on EPDM, TPO, PVC or other rubber/synthetic
surfaces. If there is any question regarding compatibility, test a small section rst. Protect building inlet ventilation from
product fumes. This manufacturer also disclaims liability for at surface application where poor drainage or ponding
water may prevail. Do not reuse empty containers. Do not use in drinking water or food systems. Protect from freezing.
CLEAN-UP: Clean tools or spills with paint thinner or mineral spirits.
WARRANTY AND DISCLAIMER: Gardner-Gibson, Inc. warranties this product to give satisfactory results when our
directions are followed in its use and application, for a period of 12 months from the date of purchase. In no event
however shall the manufacturer be liable for an amount in excess of the purchase price of the product used. If not
completely satised, return to place of purchase for a refund.
Fiber Coat+
Rubberized Premium Asphalt Coating
D-17
018
AVAILABLE SIZES
PRODUCT CODE UNIT SIZE UNIT DIMENSIONS FILL LEVEL UNIT WEIGHT PACK UPC
0181-GA 1 gal. 6.75” x 6.75” x 7.75” 3.6 qt. / 3.4 L 9 lbs. 6/case 025056018113
0185-GA 5 gal. 12” x 12” x 14.75” 4.75 gal / 18 L 47 lbs. 1 ea. 025056018557