SDS

Section 6 - Accidental Release Measures
Personal Precautions, Protective Equipment and Emergency Procedures
Avoid breathing vapors. Ventilate area. Remove all sources of ignition.
Methods and Materials for Containment and Cleaning Up
Clean up with absorbent material and place in closed containers for disposal.
Section 7 - Handling and Storage
Precautions for Safe
Handling
Do not puncture or incinerate (burn) cans. Do not stick pins, nails, or any
other sharp objects into opening on top of can. Do not spray in eyes. Do
not take internally. See product label for additional information.
Conditions For Safe
Storage, Including Any
Incompatibilities
Store and use in cool, dry, well-ventilated areas. Do not store above 120 F.
Section 8 - Exposure Controls/Personal Protection
Control parameters
Chemical Name / CAS No
OSHA Exposure Limits
ACGIH Exposure Limits
Naphtha (Petroleum), Hydrotreated Light
64742-49-0
TWA: 500 ppm;
PEL-CEILING: not determined
TLV-TWA: 400 ppm
TLV-STEL: 500 ppm
Propane
74-98-6
Not established
TWA: 1000 ppm
Butane
106-97-8
Not established
TWA: 1000 ppm
Polydimethylsiloxane
63148-62-9
Not established
Not established
N-HEXANE
110-54-3
PEL-TWA: 500 ppm
PEL-CEILING: Not determined
TLV-TWA: 50 ppm;
TLV-STEL: Not determined
Appropriate Engineering
Controls
Ventilation should be sufficient to prevent inhalation of any vapors.
General dilution and/or local exhaust ventilation in volume to keep
PEL/TLV of most hazardous ingredient below acceptable limit and lel
below stated limit.
Individual Protection
Eye/Face
Protection
None under normal use. However, use of safety glasses with splash guards
or full face shield should be used if indicated.
Skin Protection
Hand
Protection
None under normal use. Use solvent-resistant for prolonged or repeated
contact.
Other Skin
Protection
None under normal use. However, use of solvent- resistant aprons or other
clothing is recommended. Eye washes and safety showers in the workplace are
recommended.
Respiratory
Protection
None under normal use. Avoid breathing vapors. In restricted areas, use
approved chemical/mechanical filters designed to remove a combination or