3177588 Outdoor Gas Fire Pit Table Assembly & Care instructions Model: Z04-001 Please read & retain for future reference IF YOU PURCHASED THE GAS FIRE PIT TABLE ONLINE AND HAVE ANY QUESTIONS OR CONCERNS PLEASE CONTACT US WITH EMAIL OR TEXT Email:hiwarrantyservice@outlook.
Keep the instructions for future reference Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control that has been under water;” WARNING SAFETY RULES PLEASE READ THE FOLLOWING SAFETY RULES PRIOR TO OPERATION OF THE HEATER DANGER FIRE OR EXPLOSION HAZARD If you smell gas: Shut off gas to the appliance. Failure to follow property damage,personal injury,or death.
WARNING -This appliance must be installed and the gas cylinder stored in -Shut off the valve at the gas cylinder or the regulator before moving the appliance; -The tubing or the flexible hose must be changed within the prescribed intervals; -Use only the type of gas and the type of cylinder specified by the manufacturer; -Do not use the appliance in big wind weather.It is advisable to fit the dress guard available from the manufacturer.
TABLE OF CONTENTS Gas Requirements...............................................7 Leakage Test........................................................7 Cleaning and Care ............................................10 Assembly Parts ................................................. Parst List............................................................12 Problems Check List .........................................
CAUTION PLEASE READ CAREFULLY THE FOLLOWING SAFETY GUIDELINES BEFORE OPERATION. Do not use the fire pit indoors, as it may cause personal injury or property damage. Do not store or use gasoline or other flammable vapors or liquids in the heater unit. The whole gas system, hose, regulator, pilot or burner should be inspected for leaks or damage before use, and at least annually by a qualified service person. Never use an open flame to check for leaks.
Do Not use this appliance with an adjustable regulator. We suggest use this appliance with LPG cylinder of 5KG. The maximum diameter and the maximum height of the cylinder is 380mm and 450mm as shown in (Fig.1). hole, ensure the hose connect to the cylinder not touch the hot surface. Keep the cylinder in place 1: maximum diameter 2: maximum height 2 the cylinder valve. Warning: Shut off the gas cylinder when you smell gas. 1 Fig.
OPERATION AND STORAGE TO TURN ON THE FIRE PIT 2. Fully open LP cylinder valve. gas lines before proceeding. 3. Push in gas control knob and turn counterclockwise to “IGNITER”(Figure b) to light the fire pit. If a clicking sound). then release control knob. If you want a lower temperature, push in the control knob and turn clockwise TO TURN OFF THE FIRE PIT 2. Turn cylinder valve clockwise to OFF and disconnect regulator when fire pit is not in use.
A. Construction and characteristics Transportable terrace/fire pit with tank housing B. Specifications Use propane,butane or their mixtures gas only. The hose and regulator assembly must conform to local standard codes. Regulator outlet pressure should meet the corresponding appliance The appliance requires approved hose in 0.7m length. a) - Propane Storage and Handing Code,CSA B149.
CLEANING AND CARE Remove debris from the burner to keep it clean and safe for use. PARTS AND SPECIFICATIONS 73 CM Table 65CM Door Panel 58CM 108 CM OFF LOW HIGH 92.
ASSEMBLY PARTS 11
PCS N Wrench L M6 Nut 12
Step 1: Turn over the fire pit table. Attach burner ( G ) to table top ( A ) using bolts ( H ) and nuts ( L ). H G G Step 2-1: L H M6*15 x4 L K H Step 2-2: Attach the control box to the side panel ( with hole ) using bolts ( H ) , tighten them.
Step 3: I K I I K K Step 4 ：Attach Gas Cylinder Base to side panel ( B ) and side panel ( C ) using blots ( J ) and washers ( K ).
Step 5: Insert the door ( F ) to th e fire pit table . Step6 : Adjust the four plastic bottom caps to keep whole firepit table level if need.
Opinion one for glass guard Item no. Reference Image Qty.
Step 6 Pay attention to the installation direction , the metal foot pad is downward.
PROBLEMS CHECK LIST PROBLEM Burner will not light PROBABLE CAUSE SOLUTION Pressure is low Tank near empty Refill LPG tank.
