Quick guide SILENO minimo gardena.com QG_Minimo_Gardena.
GETTING STARTED WITH THE GARDENA ROBOTIC LAWN MOWER For more information and instructions, please read the complete supplied Operator‘s manual or visit www.gardena.com. Installation support videos can be found on www.gardena.com. 1. To install the charging station 3 1. Place the charging station on a flat level surface where there is open space. NOTE: To place the charging station in a limited space or in a corner, please read the Operator’s manual. 2.
1. 2. 3. 4. 2 1 3. To connect the boundary wire 3 Open the connector and lay the boundary wire in the connector. Press the connector and the wire together by using a pair of pliers. Cut off the wire 1-2 cm / 0.4-0.8 in. after the connectors. Press the boundary wire connectors onto the contact pins marked L (left) and R (right) on the charging station. 4 NOTE: The right-hand wire must be connected to the right-hand contact pin on the charging station, and the left-hand wire to the left-hand pin. 4.
To pair the robotic lawn mower and the app The GARDENA Bluetooth® App is a free app for your mobile device. The GARDENA Bluetooth® App is used for the settings and operation of the robotic lawn mower. When pairing between the robotic lawn mower and app has been confirmed, you have access to the menus and functions as long as you are within short-range (Bluetooth®). 1. 2. 3. 4. Download the GARDENA Bluetooth® App on your mobile device. Switch off the robotic lawn mower and switch it on again.
