Installation Guide

canopy through each prong, one prong at a time. Do this for all four prongs. If you loosened the

top tier roof bars during removal of the old canopy, here is when you want to tighten the top tier

roof bars in place. Doing this will allow you to install the top tier later. Once this is done, let the

bottom tier canopy rest on the roof structure. Do not fully install the bottom tier canopy yet, you

will still need access to the top of the gazebo to install the top tier.

3. Install the Top Tier Canopy – Rest the top tier canopy on the top tier frame. Pull each corner

of the top tier towards the end of the prongs. Insert ends of prongs into the corner pockets one

prong at a time. You will need to pull a little harder on the last corner pocket to complete the

installation.

4. Fully Install Bottom Tier Canopy - Begin by pulling the corners of the canopy towards the

corners of the gazebo frame. Fasten the bottom tier tightly to the frame by placing the corners of

the canopy over the corners of the gazebo frame. Do this for all four corner pockets. You will

need to pull harder on the last corner pocket, as there is less slack available. Then fasten

available Velcro straps to the roof bars. Finally, connect the bottom tier and top tier together via

the zipper lining.

5. You’re finished! Enjoy your new canopy!!!