Use and Care Guide

ASSEMBLY INSTRUCTIONS
8
CANOPY ASSEMBLY
10. Align the holes in the support canopy crossbars(N)
with holes in the canopy side bar (L) on both sides.
For each hole, insert a M5 x 30 mm bolt (AA) through
the canopy side bar (L) and into support canopy
crossbars (N). Repeat this procedure for the other support
canopy crossbars (N). Insert side support crossbars (M)
into the canopy cover (O) bottom edge and align the
holes in the bottom of canopy side bar (L). For each hole,
insert an M5 x 30 mm bolt (AA) through side support
10
11. Insert the knob (P) through the grommet hole in
the canopy (O) into the canopy side bar (L). Stretch
the canopy (O) over the top of the swing and repeat
procedure on the other side of canopy side bar (L).
You can change the tilt of the canopy (O) by adjusting
the knobs (P).
Tighten all connections using Allen wrenches (LL)
11
Hardware Used
N
L
AA
O
M
AA
AA
Hardware Used
M5 x 30 mm Bolt x 12
AA
P
K
O
Lowes.com/gardentreasures
fitting the corners over the ends of side bar (L). Repeat
this procedure for the other canopy side bar (L).
canopy crossbar (M) and into canopy side bar (L). Place
one end of the canopy (O) over the canopy side bar (L),
and open hex wrench (BB).
LL
BB
Allen
Wrench
Open
Hex
Wrench
x 2
x 2