Installation Guide

Division of LWO Corp. / P.O. Box 17125 / 3841 North Columbia Boulevard / Portland, Oregon
503-286-5372 / fax 1-503-286-4092 / www.arboria.com
445.35.86 3 of 4 updated 2/29/2012
ATTACH RAFTER BOARDS & TRELLIS
(c)
Screw through
these two holes
Line up post
corner with
marks on
header
Side frame
Block up lower ends
Step 3
• Raisetheupperendoftheassembledframe
by lifting the lower header a few inches and
slide one of the rafter sections under it, with
the pencil guide marks facing up. Adjust the
frame assembly so that the top and outside
edges of the posts line up with the pencil
marks on the rafter ends (c).
• Blockupthelowerendsofthepostssothattheposttopsareincontactwiththeraftersurfacesacross
theirfullwidth.Using21/2”screwsthroughthetwoholesatthetopofbothposts,securetheposts
to the rafter assembly.
• Placethebaseofoneof
the lattice triangles into the
groove in the upper edge of
the header, with the staple
side toward you. Line up the
center point of the lattice with
the miter joint at the top of
therafter.Withthe1”screws,
attach lattice to the back of
the rafter using one screw on
each side. Use a pilot hole if
you have a drill. Do not over
tighten (d).
• Carefullystandthearbor
upright, then lay it over on the opposite side and repeat the above procedures for attaching the other
rafter assembly and lattice insert on the opposite side.
Inside of post
Ends of lattice go into
groove on header
Screw through single
horizontal lath
Vertical
lath up
(d)
(c)