Installation Guide

6/26/2019 page 2 www.gardcolighng.com
DuraForm Accessory Installaon Instrucons
WRG-Wireguard
WRG + VSR or GSH
Wireguard nested in Visor or Glare Shield
STEP 1:
Align Wireguard to mounting points on housing as shown
below.
STEP 2:
Insert two of the provided spacers between the wireguard
clip and the housing.
STEP 3:
Secure Wireguard to housing using the provided slotted
hex head 10-24 x 5/8” screws using 27 in-lbs torque.
STEP 1:
Align Visor or Glare Shield and Wireguard to mounting
points on housing as shown below.
STEP 2:
Insert two of the provided spacers between the wireguard
clip and the Visor or Glare Shield.
STEP 3:
Secure Wireguard to housing using the provided slotted hex
head 10-24 x 5/8” screws using 27 in-lbs torque.
Note: Wireguard can be mounted over Visor or Glare Shield.
When nesting wireguard and Visor or Glare Shield together use
the longer 5/8” screws that are provided with the Wireguard.
442295035451 REV C
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
CAN ICES-005 (A) / NMB-005 (A)
Signify North America Corporation
400 Crossing Blvd, Suite 600
Bridgewater, NJ 08807, USA
Phone: [phone]