Installation Instructions
Table Of Contents
- 1 INTRODUCTION
- 2 GENERAL INFORMATION
- 3 INSTALLATION
- 3.1 Target Group
- 3.2 Definition of the Door Hinge (Right of Left Door)
- 3.3 Test Installation
- 3.4 Metallic and Non-Metallic Doors
- 3.5 Bolt Gauge
- 3.6 Door Status Contact
- 3.7 Transportation Guidelines
- 3.8 Replacement after a Burglary Attempt
- 3.9 Measurement Diagrams for Installation
- 3.10 Installation in Lockers with Non-Metallic Doors (Except Glass)
- 3.11 Installation in Lockers with Metallic Doors
- 3.12 Installation in Lockers with Glass Doors
- 4 COMMISSIONING
- 5 CONFIGURATION
- 5.1 General Information
- 5.2 Setup for Configuration in GAT Config Manager
- 5.3 View and Edit the GAT ECO.Side Lock 7000 BA Configuration Settings
- 5.4 Upload Configuration Settings to the GAT ECO.Side Lock 7000 BA
- 5.5 Updating the GAT ECO.Side Lock 7000 BA Firmware
- 5.6 Configuration Settings of the GAT ECO.Side Lock 7000 BA
- 6 OPERATION
- 7 CLEANING AND MAINTENANCE
- 8 TECHNICAL DATA
GAT ECO.Side Lock 7000 BA / NW BA
Configuration
42
HB_GAT-GAT-ECOSide-Lock7000-BA--EN_14
www.gantner.com
► Click on the “(2) Configure” button (2 in Figure 5.4).
o The GAT Configurator window opens (Figure 5.5).
Figure 5.5 – GAT Configurator window
5.4 Upload Configuration Settings to the GAT ECO.Side Lock 7000 BA
When you are finished configuring the GAT ECO.Side Lock 7000 BA settings in GAT Config Manager, it is
important to finalize the configuration by uploading the file to the lock. Complete the following steps to finalize the
configuration.
► Click on “OK” in the GAT Configurator Window (Figure 5.5).
o The following confirmation window opens.
► Click “Yes” to apply the configuration to the lock.
o The configuration settings are uploaded to the GAT ECO.Side Lock 7000 BA.