Installation Instructions
Table Of Contents
- 1 INTRODUCTION
- 2 GENERAL INFORMATION
- 3 INSTALLATION
- 3.1 Target Group
- 3.2 Definition of the Door Hinge (Right of Left Door)
- 3.3 Test Installation
- 3.4 Metallic and Non-Metallic Doors
- 3.5 Bolt Gauge
- 3.6 Door Status Contact
- 3.7 Transportation Guidelines
- 3.8 Replacement after a Burglary Attempt
- 3.9 Measurement Diagrams for Installation
- 3.10 Installation in Lockers with Non-Metallic Doors (Except Glass)
- 3.11 Installation in Lockers with Metallic Doors
- 3.12 Installation in Lockers with Glass Doors
- 4 COMMISSIONING
- 5 CONFIGURATION
- 5.1 General Information
- 5.2 Setup for Configuration in GAT Config Manager
- 5.3 View and Edit the GAT ECO.Side Lock 7000 BA Configuration Settings
- 5.4 Upload Configuration Settings to the GAT ECO.Side Lock 7000 BA
- 5.5 Updating the GAT ECO.Side Lock 7000 BA Firmware
- 5.6 Configuration Settings of the GAT ECO.Side Lock 7000 BA
- 6 OPERATION
- 7 CLEANING AND MAINTENANCE
- 8 TECHNICAL DATA
GAT ECO.Side Lock 7000 BA / NW BA
Installation
www.gantner.com
HB_GAT-GAT-ECOSide-Lock7000-BA--EN_14
29
3.12 Installation in Lockers with Glass Doors
For lockers with glass doors, the GAT ECO.Side Lock 7000 BA is mounted on the left or right inner locker wall
depending on whether it is a right or left-hinged locker door. The GAT NET.Lock Bolt Set 7300 (with metal support
attached) are glued to the inner side of the locker door. Furthermore, a recess in the printing on the locker door or
door label may be necessary for the status LED. See the diagram below and the following installation instructions.
1. GAT ECO.Side Lock 7000 BA
2. GAT NET.Lock BoltSet 7300
3. 3 x mounting screws for the GAT ECO.Side Lock 7000 BA
5. Door contact
7. LED position
12. Metal support for adhering the GAT NET.Lock BoltSet 7300 (the metal support is included with the GAT
NET.Lock BoltSet 7300 and is delivered attached to the bolt set).
Figure 3.15 - Installation in a locker with glass, right-hinged door (dimensions in mm – inches shown in brackets)