Installation Instructions
Table Of Contents
- 1 INTRODUCTION
- 2 GENERAL INFORMATION
- 3 INSTALLATION
- 3.1 Target Group
- 3.2 Definition of the Door Hinge (Right of Left Door)
- 3.3 Test Installation
- 3.4 Metallic and Non-Metallic Doors
- 3.5 Bolt Gauge
- 3.6 Door Status Contact
- 3.7 Transportation Guidelines
- 3.8 Replacement after a Burglary Attempt
- 3.9 Measurement Diagrams for Installation
- 3.10 Installation in Lockers with Non-Metallic Doors (Except Glass)
- 3.11 Installation in Lockers with Metallic Doors
- 3.12 Installation in Lockers with Glass Doors
- 4 COMMISSIONING
- 5 CONFIGURATION
- 5.1 General Information
- 5.2 Setup for Configuration in GAT Config Manager
- 5.3 View and Edit the GAT ECO.Side Lock 7000 BA Configuration Settings
- 5.4 Upload Configuration Settings to the GAT ECO.Side Lock 7000 BA
- 5.5 Updating the GAT ECO.Side Lock 7000 BA Firmware
- 5.6 Configuration Settings of the GAT ECO.Side Lock 7000 BA
- 6 OPERATION
- 7 CLEANING AND MAINTENANCE
- 8 TECHNICAL DATA
GAT ECO.Side Lock 7000 BA / NW BA
Installation
22
HB_GAT-GAT-ECOSide-Lock7000-BA--EN_14
www.gantner.com
3.10 Installation in Lockers with Non-Metallic Doors (Except Glass)
For lockers with non-metallic doors, the GAT ECO.Side Lock 7000 BA is mounted on the left or right inner locker
wall depending on whether it is a right or left-hinged locker door. The GAT NET.Lock Bolt Set 7100 is mounted on
the inside of the locker door. A drill hole is required in the locker door for the status LED. See the diagram below
and the following installation instructions.
For glass door installation instructions see “3.12. Installation in Lockers with Glass Doors”.
1. GAT ECO.Side Lock 7000 BA
2. GAT NET.Lock Bolt Set 7100
3. 3 x mounting holes for the GAT ECO.Side Lock 7000 BA (the use of threaded sleeves is recommended)
5. Door contact
6. 3 x mounting screws for the GAT NET.Lock BoltSet 7100
7. Hole for LED
Figure 3.9 - Installation in a locker with non-metallic, right-hinged door (dimensions in mm – inches shown in brackets)