Installation Instructions
Table Of Contents
- 1 INTRODUCTION
- 2 GENERAL INFORMATION
- 3 INSTALLATION
- 3.1 Target Group
- 3.2 Definition of the Door Hinge (Right of Left Door)
- 3.3 Test Installation
- 3.4 Metallic and Non-Metallic Doors
- 3.5 Bolt Gauge
- 3.6 Door Status Contact
- 3.7 Transportation Guidelines
- 3.8 Replacement after a Burglary Attempt
- 3.9 Measurement Diagrams for Installation
- 3.10 Installation in Lockers with Non-Metallic Doors (Except Glass)
- 3.11 Installation in Lockers with Metallic Doors
- 3.12 Installation in Lockers with Glass Doors
- 4 COMMISSIONING
- 5 CONFIGURATION
- 5.1 General Information
- 5.2 Setup for Configuration in GAT Config Manager
- 5.3 View and Edit the GAT ECO.Side Lock 7000 BA Configuration Settings
- 5.4 Upload Configuration Settings to the GAT ECO.Side Lock 7000 BA
- 5.5 Updating the GAT ECO.Side Lock 7000 BA Firmware
- 5.6 Configuration Settings of the GAT ECO.Side Lock 7000 BA
- 6 OPERATION
- 7 CLEANING AND MAINTENANCE
- 8 TECHNICAL DATA
GAT ECO.Side Lock 7000 BA / NW BA
Introduction
10
HB_GAT-GAT-ECOSide-Lock7000-BA--EN_14
www.gantner.com
1.4 Target Group
This manual contains information relevant for the different stages in the operating life of the GAT ECO.Side Lock 7000
BA / NW BA. Information about the installation, commissioning, and service/maintenance of the GAT ECO.Side Lock
7000 BA / NW BA is separated into corresponding chapters. When a chapter is intended for a specific audience, this
is clarified at the beginning of the chapter.
Information for the following target groups is available in this manual:
- Installation technicians (installation, operation, configuration).
- Service technicians and cleaning personnel (service and maintenance).
- End users of the GAT ECO.Side Lock 7000 BA / NW BA (user manual).
Where not explicitly stated, the information in this manual is intended for all target groups in general.
CAUTION! Injury and property/equipment damage. The tasks described in each chapter must only be
performed by the specified target group. Unqualified personnel who perform the described tasks risk personal injury
or damaging property/equipment.
1.5 Formatting
Safety-Critical Information
The following formatting (with example text) is used in this manual to display important, safety-critical information
that must be read and followed.
NOTE! Following on from this signal word in the manual is a reference text that must be read and followed. The
reference text contains important information. Non-observance can lead to damage of the device or associated
equipment.
Non-Safety-Critical Information
The following formatting (with example text) is used in this manual to display important, but not safety-critical
information.
The text accompanying this symbol contains interesting information relevant to the current chapter. You do not
necessarily need to read this text; however, it will help you better understand the information in this section or
provide interesting tips for the described device or the operation of the software.
Instructions and Results
Instructions, which must be completed by the reader, and the results of these instructions are formatted as follows.
► This symbol represents an action or instruction that that must be followed.
o This symbol represents the result after completing the previous instruction.