Installation Guide

INSTALLATION INSTRUCTIONS
NOTE: The cover should be installed on a smooth, flat,
non-porous surface. To install on an irregular surface,
use a proper amount of caulking to ensure a watertight
seal between the back of the cover and the mounting
surface.
1. Disconnect power to circuit by removing fuse or turn
breakers to OFF before installing.
2. Remove the existing receptacle cover, if any, and
discard.
3. Back off the mounting screws that hold the GFCI or
receptacle to the junction box but do not remove
screws.
4. Place the cover on the box while mounting screws
come into the cover through the keyhole, and slide the
assembly to left. (see Figure 3).
Center the device in the box. Tighten screws.
5. If mounting to an FS or outdoor junction box use the
four screws provided to further secure the assembly to
the box.
6. DO NOT OVER TIGHTEN SCREWS.
7. Choose appropriate insert and snap in by putting one
long edge in place first and rotating the plate over the
device. (If device is in the way, loosen screws and
move left or right). Discard other Insert (s).
8. For best rain protection, be sure to route cords through
the cord outlet and press the cover firmly until it snaps
closed.
WARNING - Turn off all power to circuit before installing
this device. Improper wiring of any electrical device can
cause serious injury or death. These wiring devices
should only be installed by an Electrician or other
qualified person.
CAUTION - This cover should be installed in
accordance with the National Electrical Code, and all
applicable local codes and standards.
WHILE -IN-USE COVER DESCRIPTION.
This product is a weatherproof cover that is intended to enclose an electrical device (Duplex, GFCI and 1 3/8” round)
(Deep Cover also for use with 1 9/16” round) and protect the device from inclement weather even when a plug and
cord are inserted in it. It is designed to install quickly and easily (see instructions below) and provide an attractive,
durable finish that will yield long lasting results.
Application
The cover should be installed in areas subject to saturation from water or other liquids. (see description for "Wet
Location" and "Damp Location" in the National Electrical Code). The single gang 3 1/8” cover can be mounted either
horizontally or vertically as long as the hinge is in the top corner. See Figure 1 (A-B) for applicable mounting and
attachment options. See Figure 2 for double gang applicable mounting and attachment options. The cover includes
multiple inserts, so it can be used to cover different types of electrical devices.
WEATHERPROOF WHILE-IN-USE COVER SERIES
INSTALLATION INSTRUCTIONS
Figure 1. (A) Single gang 3 1/8” Vertical
Figure 2. Double gang
Figure 3
INSCRD004
Figure 1. (B) Single gang 3 1/8” Horizontal
Figure 1. (C) Single gang 4 1/2”