Instruction Manual

12
English
WARNING: NEVER attempt to clear stuck ammunition by firing an additional
pellet through the gun.
CAUTION: Be sure that the safety catch is «ON» prior to clearing an obstruction.
With the loading lever in its closed position parallel to the barrel, insert a ramrod of an
appropriate diameter for the calibre of your rifle (4.5 mm/.177 in. or 5.5 mm/.22 in.) into
the muzzle and push until the barrel is empty of ammunition. If a pellet has become stuck,
it will be in the loading port. Lower the loading lever and the feeding bar will emerge with
the pellet in it.
Use the ramrod to clean the hole where the pellet is housed. Then clean the barrel with the
ramrod brush to remove any lead particles that may have become stuck to the rifling.
NOTE: Always discard defective or deformed ammunition.
CAUTION: When you are ready to put your gun away, with the barrel pointed
toward the floor, make sure that there is no ammunition in the barrel. This way you
will prevent any possible accident the next time you use your gun.