Specifications

20 21

10X Quick-Shot Only: If a pellet is stuck in the magazine, grab the front side of the 10X Quick-Shot Mechanism and move it back and

forward to unlock the system and remove the pellet. See picture L.

Remove the magazine from the 10X Quick-Shot system and break the barrel. Pull slightly up the 10X Quick-Shot system and insert a

cleaning rod of the caliber of the air rie into the barrel. Pull the rod through the barrel until the pellet is removed. See picture M.

10X GEN2 Quick-Shot Only: Remove the magazine from the 10X GEN2 Quick-Shot system and break the barrel. Insert a cleaning rod

of the caliber of the air rie into the barrel. Pull the rod through the barrel until the pellet is removed.

For both 10X and 10X GEN2 Quick-Shot. If you loaded your pellet backwards (skirt facing down), please insert the new pellets into

the magazine in the right direction in order to pull out the ones wrongly inserted.

NEVER attempt to clear stuck ammunition by ring an additional pellet through

the gun as it may damage the gun. Always be sure the safety is “ON” prior to

clearing an obstruction. When you are nished, clean the barrel with the brush

attachment of the cleaning rod to remove any metal or polymer particles that

may be adhered to the barrel riing.

PROCEDURE FOR CLEARING STUCK AMMUNITION

WARNING:

Please make sure that you have the safety ON at all times until you are ready to shoot.

If you could not extract the magazine, you can

remove the 10X and 10X GEN2 Quick-Shot system.

Proceed to take apart the 10X and 10X GEN2 Quick-

Shot system by extracting the linkage (picture

) (in the case of the 10X GEN2 you will have to

remove two linkages, and if your air rie has a rear

sight, you will need to remove the screw that holds

the rear sight) and the two metal rods located in

each side of the mechanism (picture

)

Extract the linkage

Extract the two metal rods

English

FOR 10X QUICK-SHOT ONLY

FOR 10X GEN2 QUICK-SHOT ONLY

1. Remove front mounting rod

2. Remove rear mounting rod

3. DO NOT remove this rod

1 2 3