Instruction Manual

1.) SELECTING THE CORRECT RAIL MOUNT FOR YOUR PISTOL
The Flashlight attaches to either a 3/8” grooved receiver or to a 5/8" “weaver-style” base. The laser is shipped with
the mounting rails for a “weaver-style” mount already installed. If you need to attach this device to a 3/8" grooved
receiver, you will need to loosen the rail screw and rotate the 5/8" weaver rail so the the 3/8" is visable.
2.) ATTACHING THE CORRECT MOUNT TO THE DEVICE
Simply slide the appropriate rail onto your gun and tighten it into place utilizing the rail attaching screw. Note the
“weaver-style” rail utilizes a lock screw to prevent its slippage under recoil. This lock screw should be t into the
groove found on most “weaver-style” mounts.
3.) ACTIVATING THE FLASHLIGHT
 DONOTLOOKDIRECTLYINTOTHEFLASHLIGHTBEAMOUTPUTAPERTUREDURINGOPERATION.PERMANENT
EYEDAMAGEMAYRESULT.
3A.) Installing The Batteries
Your new ashlight is powered by (1) one CR123 battery. Rotate push button counter clockwise to remove. Insert batter
(+) end facing out. Install push button switch by rotating clockwise until tight.
3B.) Main On-Off Switch
With this switch, you may turn the laser on or off.
DANGER
!
WARNING
!
CAUTION
!