62120LLCP PRECISION LASER SIGHT AND LIGHT INSTRUCTION MANUAL
TABLE OF CONTENTS A.) B.) C.) D.) E.) F.) G) H.) MOUNTING THE LASER AND LIGHT TO A 1" SCOPE TUBE. REPLACING THE FLASHLIGHT BATTERIES. REPLACING THE LASER BATTERIES. REPLACING THE LASER OR FLASHLIGHT SWITCHES. POSITIONING THE REMOTE SWITCHES. ZEROING THE LASER SIGHT. ADJUSTING THE LASER WINDAGE AND ELEVATION. MAINTAINING YOUR LASER SIGHT AND LIGHT.
2 COMPONENTS OF THE KIT Triple Mount Flashlight Laser sight 1 Push button and 1 remote switch for flashlight 1 Push button and 1 remote switch for laser sight 1 CR123A 3V battery for flashlight 3 LR44 1.5V batteries for laser sight 2 Velcro stickers 3 “L” hex wrench set ! DANGER ! WARNING BE CERTAIN THAT YOUR AIR GUN IS UNLOADED AND POINTING IN A SAFE DIRECTION. ! CAUTION ATTENTION: THIS LASER TARGET DESIGNATOR IS A POWERFUL DEVICETHAT REQUIRES ! DANGER SPECIAL ATTENTION FOR ITS USE.
. Place upper half of mount onto laser sight and flashlight, DO NOT TIGHTEN SCREWS YET. Before tightening the screws in the upper half of the rings, adjust the laser sight and flashlight back or forward for the best position to allow removal of the push button switches or installation of the momentary ON/OFF switches. Align (rotate) the vertical and horizontal axes of the laser sight for the proper alignment of the windage and elevation of the laser dot.
4 E.) POSITIONING THE REMOTE SWITCHES 1. Once you have decided the location of the switches on the rifle stock, place adhesive side of velcro strip on the stock of the rifle by pressing the adhesive portion against the stock. 2. Attach the other adhesive portion to the back of the pressure sensitive switches by pressing the adhesive side of the surface of the Velcro strip against them. 3. Secure the pressure sensitive switches to the stock by pressing both parts of the Velcro together. F.
H.) MAINTAINING YOUR LASER SIGHT AND LIGHT Do not attempt to disassemble or clean the laser sight or the flashlight internally. This will invalidate the warranty. If the laser sight or the flashlight require repairs or adjustment, complete instructions can be found in the warranty. The external surfaces should occasionally be wiped clean with the lens cloth provided, a soft lint-free cloth, or an optical quality lens paper.
6 The 62120LLCP laser product is designated as class 3R during all procedures of operation. SPECIFICATIONS: MODEL 62120LLCP Laser Sight Wavelength 650nm Index-Guided Laser Diode Laser Sight Power Class 3R (5mw) Output Power Flashlight 3v., High Pressure Xenon Bulb 96600 Lx Beam Diameter < 3mm at Aperture Divergence < 1 mrad Transverse Beam Mode Tem 00 Weight (Laser, Flashlight, 1” Tube Mount and Batteries) 7 oz.
©2009 GAMO OUTDOOR USA®, Inc Ft. Lauderdale, FL 33314 USA Printed in China 62120LLCP-Manual.indd • BD120309 gamousa.
